Rubber Stamper's Delight™
by: Doreen Chambers, SCD
Wolf Stamp © Northwoods Rubber StampsMaterials:
- Delight™ air dry modeling compound
- Rolling Pin
- Freezer Paper or waxed paper
- Stamp of your choice
- Ink Pad (Memories, Ancient Page work best, your choice of color. Pigment inks will work but you must be very careful in cutting out your image, the ink may smear!)
- Chalks
- Cotton Swabs
- Cotton Balls
- Plaid Royal Coat Decoupage Finish
- Paintbrush
Roll out the Delight™ modeling compound just like pie dough. I roll it out on top of the waxy side of freezer paper.
Ink up the stamp of your choice, carefully imprint into the Delight™ and lift gently.
Carefully cut out the image, leave about a 1/2 inch margin around image. Gently tear out your image and leaving the edges rough.
Air-dry your work for at least 24 hours. Do not put it in the oven or it will become puffy.
After it's dried, color in your image with chalk. For the leather look, use varying shades of browns around the torn edges. Apply chalks with cotton swab. When finished coloring, buff the piece with a cotton ball. Seal your piece with Royal Coat. Adhere your piece with silicone glue.
You are only limited by your imagination!